Power-management af high-power Li-Ion systemer

Power-management af high-power Li-Ion systemer

Linear Technology lancerer 7-kanals I2C-kontrolleret power management IC til high power 1-celle Li-Ion systemer (in english).

Linear Technology Corporation announces the LTC3675, a highly integrated general-purpose power management solution for high power single cell Lithium-Ion/Polymer cell systems. The device features seven independent rails, with I2C control, flexible sequencing and fault monitoring in a compact 28mm2 QFN package.

The LTC3675 contains four high efficiency synchronous step-down regulators, a high current/high efficiency buck-boost regulator, a synchronous boost regulator, a dual-string 40V-LED driver and an always-on LDO.   Pushbutton ON/OFF/RESET control, precision enable inputs and a power-on reset output provide flexible and reliable power-up sequencing.  The LTC3675's I2C interface provides complete regulator control, status reporting and a maskable interrupt output. Quiescent current is only 16uA with all DC/DCs off to maximize battery run time.

The LTC3675's four constant frequency current-mode buck switching regulators are internally compensated, providing up to 1A, 1A, 500mA and 500mA output currents, respectively, with complete I2C control.

Further, the buck power stages can be paralleled to deliver up to twice the output current with a single inductor. The buck regulators can operate in two different modes. In pulse-skipping mode, the regulator will skip pulses at light loads, but will operate at a constant frequency of 2.25MHz at higher loads.

In Burst Mode operation, the regulator will burst at light loads for best efficiency, and at higher loads will operate in constant frequency PWM mode for lowest noise performance. I2C may be used to control the device, enabling mode of operation, feedback regulation voltage and switch slew rate. The bucks have forward and reverse current limiting, soft-start to limit inrush current during start-up, short-circuit protection and slew rate control for lower radiated EMI.

The LTC3675's buck-boost regulator is a 2.25MHz voltage mode regulator designed to deliver up to 1A load current for a typical programmed output voltage of 3.3V. The regulator can be enabled via its enable pin or via I2C. The mode of operation (Burst Mode or PWM), feedback regulation voltage and switch slew rate can all be controlled via I2C. The buck-boost regulator also features forward current limiting, soft-start to limit inrush current during start-up,  short-circuit protection and slew rate control for lower radiated EMI. 

The LTC3675's boost regulator is designed to deliver up to 1A load current for a programmed output voltage of up to 5V. Boost DC/DC enable, mode of operation (Burst Mode or PWM), feedback regulation voltage and switch slew rate can all be controlled via I2C. The boost regulator has forward and reverse current limiting, soft start to limit inrush current during start-up, short-circuit protection, slew rate control for lower radiated EMI and true output disconnect when in shutdown.

The LTC3675's constant frequency, current mode 40V LED driver can regulate up to 25mA of current through each of two series 10-LED strings. LED enable, 60dB brightness control and up/down gradation are programmed using I2C. The LED driver can be configured as a general purpose high voltage boost converter with a 1.6A (typ) switch current limit. Given its high duty cycle operation, it can boost from below 3V to up to 40V output at 55mA.

The LTC3675 is available from stock in a thermally enhanced, low profile (0.75mm) 44-pin 4mm x 7mm QFN package. 1000-piece pricing starts at $5.05 each for the E grade, with an operating junction temperature range of -40°C to +125°C. 
www.linear.com/3675
 

31/8 2010
  • Strålingstolerant GaN-baseret POL-konverter

    Strålingstolerant GaN-baseret POL-konverter

    power ›Microchip præsenterer POL-05-20S-T, der er en strålingstolerant point-of-load (POL) konverter, der er designet til at imødekomme de høje effektkrav i rumapplikationer med mere (in english).
  • RECOM powerdesigns integreres nu i CELUS designplatformen

    RECOM powerdesigns integreres nu i CELUS designplatformen

    power ›En række af RECOM's powerdesigns bliver nu en del af CELUS designplatformen, hvor de indgår i 37 af CELUS's såkaldte CUBO's, der kan beskrives som digitale datablade (in english)
  • Ultrakompakt 600W AC/DC-strømforsyning

    Ultrakompakt 600W AC/DC-strømforsyning

    power ›Vox Power har udvidet sin EIRE-familie af single-output AC/DC-strømforsyninger med EIRE600, der er kompakt 600 W-strømforsyning, som måler blot 5 × 3 tommer og har en ekstremt lav profil på 1,1 tommer (in english).
  • 3,300 V SiC MOSFET-modul til industrielt udstyr

    3,300 V SiC MOSFET-modul til industrielt udstyr

    power ›Toshiba lancerer ny 3,300 V SiC MOSFET-modul til industrielt udstyr, der kan hånterere høje peak-strømme, hvilket er med til at forøge systempålideligheden.
  • Navitas og NVIDIA samarbejder om 800 V til 12 V power-delivery board

    Navitas og NVIDIA samarbejder om 800 V til 12 V power-delivery board

    power ›Navitas og NVIDIA udvikler 24 kW power-delivery board, der i ét trin kan konvertere 800 VDC direkte til 12 VDC og dermed eliminere 50 V IBC powertrinnet, hvilket booster systemeffektiviteten og reducerer boardstørrelsen (in english).
  • Rohde & Schwarz afholder power-seminarer

    Rohde & Schwarz afholder power-seminarer

    t-og-m ›Rohde & Schwarz afholder henholdsvis den 3. november (Aalborg) og 4. november (Sønderborg) heldagsseminarer, der fokuserer på forskellige testaspekter med relation til powerelektronik.
  • Microchip og Navitas samarbejder om 800V referencedesign

    Microchip og Navitas samarbejder om 800V referencedesign

    power ›Microchip og Navitas udvikler 800V-til-6V referencedesign, der kombinerer digital powerkontrol og hardwarebaseret sikkerhed, der kan accelerere udviklingen af højeffektive OCP (Open Compute Project) rack power applikationer.
  • Lavspændings GaN FETs til AI datacentre og robotløsninger

    Lavspændings GaN FETs til AI datacentre og robotløsninger

    aktive-komponenter-og-embedded-sw ›Renesas udvider porteføljen af GaN-komponenter med første 100V E-mode GaN, der bl.a. vil være oplagt at bruge i datacentre og forskellige typer af robotter (in english).